Residential window film
Security Window Film in Toronto: Delaying Forced Entry
NorthGuard installs security window film on Toronto and GTA homes to hold shattered glass together and delay forced entry at patio doors, basements and ground-floor windows. Installed price is $16 to $26 per square foot before HST, with a free in-home estimate.
This page is about intruders and forced entry. If your concern is accidental breakage, such as kids, pets or storm debris, read about safety window film that holds glass fragments instead.
Security Window Film from NorthGuard in Toronto and the GTA
NorthGuard installs security window film (Madico, SunTek, Solar Gard) that reinforces residential glass, holds shards together on impact, and helps delay forced entry. Clear, nearly invisible protection for ground-floor windows, patio doors, and basement openings across Toronto and the GTA.
Security window film is a polyester sheet bonded to the interior of existing glass. When the pane is struck, the glass can still crack — the film’s job is to hold fragments together so a climb-through opening takes more time and noise to create. That delay is the product: minutes that matter for alarms, cameras, neighbours, and locks — not a promise of unbreachable glass.
On Toronto and GTA homes we start with risk openings first: patio doors, walk-outs, basements, ground-floor lites, and glass near alleys or high foot traffic. We measure each opening, note glass type (single pane, IGU, tempered), and recommend mil thickness after we see the frame and access — not from a phone photo alone.
Clear residential security film is usually nearly invisible once cured. You keep natural light and curb appearance while adding a layer that pairs with hardware and detection systems. Film does not replace deadbolts, lighting, or alarms; it addresses the glass failure mode those systems cannot.
Every NorthGuard security install is documented: which film product went on which openings, manufacturer product terms as they apply, and written workmanship terms at handoff. Aftercare for the cure window is explained before we leave so you know when wet cleaning is safe.
Benefits of Security Window Film
NorthGuard security window film holds shattered glass in place, which delays smash-and-grab and forced entry without darkening the room.
- Holds shattered glass in place during impact
- Delays smash-and-grab and forced entry attempts
- Nearly invisible — does not darken rooms
- Works on single-pane and many double-pane windows
- Pairs with alarms for layered home security
- Manufacturer product warranty as stated for the film installed
Where Security Window Film fits best
NorthGuard puts security window film first on ground-floor and basement glass, sliding patio doors, front door sidelights and vacant secondary properties.
What homeowners ask about Security Window Film
NorthGuard explains security window film opening by opening: what the film does on each kind of glass, what it does not do, and what the written quote covers.
Mil thickness: how we choose 8, 12, or 14 mil
Thicker film generally means more hold and more delay under attack, with more care required at edges and corners. Many GTA homes land in the 8–14 mil range on high-risk glass; lighter grades may suit lower-risk interior or secondary panes. We match mil to glass construction, lite size, and risk — and we will say when a different approach (hardware, laminated replacement) is the better spend.
Patio doors and large sliding glass
Sliding patio doors are among the most common smash-and-grab targets because they create a large opening quickly. Security film on the interior surface is specified to hold the lite together after impact. We also check track condition and lock engagement — film is not a fix for hardware that does not latch.
Basements, walk-outs, and secondary suites
Basement windows and walk-out glass often sit at eye level from grade or are hidden from the street. We prioritize these openings on estimates and note access constraints (wells, grates, finished rooms) that affect labour and product choice.
What security film does not do
Security window film is not bulletproof glass. NorthGuard security film does not stop a determined attacker indefinitely, and it does not fix fogged sealed units or rotten frames. NorthGuard writes each scope so the homeowner knows which openings are covered and what risk remains.
Cost, timelines, and free estimates
Installed planning range before HST is $16 to $26 per square foot. Square footage, mil, access, and glass condition move the price. We do not publish a one-size phone quote. Free in-home estimates include a written scope after measure. Small jobs carry a travel and project-management charge. The final price is the measured written quote. Most residential security jobs complete in a day once materials and schedule align.
How NorthGuard installs Security Window Film
NorthGuard installs security window film in four steps: a free home assessment, film selection, professional installation, and a walkthrough with aftercare.
- 1
Free home assessment
NorthGuard walks your property, notes vulnerable glass, and recommends mil thickness for each opening.
- 2
Film selection
Choose clear security film from entry-level to heavy-duty residential grades with sample review.
- 3
Professional install
Installers prep glass, apply film, and edge-seal for a clean, long-lasting finish.
- 4
Walkthrough & aftercare
NorthGuard inspects every pane with you and leaves care instructions and the warranty documents in writing.
Security Window Film FAQ
NorthGuard security window film holds broken glass together and delays forced entry on Toronto and GTA homes; it does not make glass unbreakable, and the installed price is a measured written quote within the published $16 to $26 per square foot range before HST.
Does security film stop break-ins completely?
No security film can guarantee that glass will never be broken through. Security film is designed to hold glass together and delay entry so alarms, neighbours, or locks have more time to matter. It is a layer of protection, not invincible glass.
How thick should residential security film be?
Many Toronto homes use 8–14 mil on high-risk openings. We match thickness to glass type, frame, and risk profile during your free estimate.
Will security film change how my windows look?
Quality clear security film is optically clear or only faintly tinted. From the street and inside, most homeowners notice little to no visual change.
Can you install on double-pane windows?
Yes, on the interior surface of most IGU windows. We assess glass and exposure so the film selection avoids thermal stress issues.
Is security film worth it compared with new laminated glass?
Laminated glass is excellent but costly and disruptive. Security film is the common upgrade on existing residential glass — real delay against forced entry without a full window replacement.
Should I DIY thick security film myself?
Thick security film is unforgiving: edges, corners, and adhesion determine whether it performs. Most homeowners who want reliable results hire a professional installer and keep the manufacturer warranty documentation.
Other NorthGuard films related to Security Window Film
NorthGuard pages linked below cover the films, prices and areas most often quoted together with security window film in Toronto and the GTA.
Get your free residential estimate
Tell us about your windows. We aim to reply within one business day across Toronto and the GTA.